Les Paul Wiring Harness- Bumblebee

These aren’t your average bargain-bin electronics with cold solder joints and scratchy signals. Every CLE GUITAR WORKS harness is hand-built and road-tested using only premium components — because your tone deserves better, and cheap parts have no place between your pickups and your amp.

Each harness includes:

★ CTS POTENTIOMETERS for smooth, consistent control

★ SWITCHCRAFT SWITCHES and DUAL-CONTACT JACKS for rock-solid reliability

★ Hand-wired by yours truly — with over 20 YEARS of experience wiring and modding guitars for A-LIST ARTISTS around the world

★ Vintage-spec push-back wire

★ Or Pure 20 AWG 5N SILVER lead wire (Depending on the series), paired with 16 AWG ground bus wire — delivering a clean, stable, and transparent signal chain.

Also included:

★ JUPITER CONDENSER CO. CAPACITORS — premium, American-made caps trusted by even the most tone-obsessed audiophiles. They deliver the clarity and musicality your rig deserves, both in the STUDIO and ON STAGE.

Wiring is the unsung hero of your signal chain. It’s not flashy — but it’s the main artery that carries your tone from pickup to amp:

UNCOLORED. UNFILTERED. EXACTLY how it’s meant to sound.

DON’T LET WEAK PARTS CHOKE YOUR SIGNAL.

DON’T LET CHEAP WIRING FAIL YOU ON STAGE.

INVEST IN RELIABILITY. INVEST IN TONE.

Les Paul Pre-Wired Kit (Bumblebee Spec)

SKU: D-LP-20S-BB

★ Kit Specs

• Potentiometers: (4) CTS 500K Long Shaft Audio Taper

• Capacitors:

  – .015µF Jupiter Bumblebee (Neck)

  – .022µF Jupiter Bumblebee (Bridge)

  (Aluminum Foil, Paper-in-Oil Construction)

• Jack: Switchcraft Dual-Contact ¼” Mono Jack

• Wire: Vintage-spec cloth push-back wire

• Ground Bus: 16 AWG tinned copper

• Solder: Sn63/Pb37 rosin core for superior flow and strength

• Configuration: 50s-style or Modern style wiring

• Optional: Volume treble bleed circuit

★ Compatibility

Fits most USA Gibson Les Paul models with carved tops and long shaft (3/4”) pots.

Will also fit most Epiphone LP models; however, note that factory components (typically Alpha-brand pots) use smaller metric-sized shafts and holes.

To install this kit on Epiphone models, pot holes must be carefully reamed out to accommodate ⅜” CTS potentiometers and US-sized hardware.